Toro Flex-Force Power System 51833, Operator'S Manual

Page: 9 / 64

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
Allen wrench 1 Unfold the handle.
2
Auxiliary handle assembly 1 Install the auxiliary handle.
Important:
The battery pack is not fully charged when you purchase it. Before using the tool for the
first time, refer to Charging the Battery Pack (page 13) .
1
Unfolding the Handle
Parts needed for this procedure:
1 Allen wrench
Procedure
1. Unfold the handle (A of Figure 3 ).
2. Align the locking button on the lower shaft with the slotted hole on the upper shaft and slide the 2 shafts
together (B and C of
Figure 3 ).
Note:
The locking button clicks into the slotted hole when the shafts are secured (D of Figure 3 ).
3. Using the provided Allen wrench, tighten the screw on the shaft connector until it is secure (E of Figure 3 ).
7