Toro Dingo 22429, Operator'S Manual

Page: 6 / 20

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
No parts required
–
Prepare the traction unit.
Right shield bracket (3 holes)—200/300
Series or TX 400/500 Series only
1
Left shield bracket (3 holes)—200/300
Series or TX 400/500 Series only
1
Self-tapping screw (5/16 x 3/4 inch) 4
Right shield bracket (2 holes)—TX 1000
only
1
Left shield bracket (2 holes)—TX 1000
only
1
Bolt (1/4 x 3/4 inch)—TX 1000 only 4
2
Locknut (1/4 inch)—TX 1000 only 4
Install the shield brackets.
Shield support (1 bend)—200/300
Series or TX 400/500 Series
2
Shield support (2 bends)—TX 1000 only 2
Shield 1
Bolt (1/4 x 1-1/2 inch) 8
Washer 8
3
Locknut (1/4 inch) 8
Assemble the operator shield.
Chip guard 1
Guard pin 1
4
Hairpin cotter 1
Install the chip guard.
1
Preparing the Traction Unit
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Lower the loader arms.
3. Engage the parking brake (if applicable).
4. Shut off the engine and remove the key.
6