Toro Dingo 22366, Installation Instructions Manual

Page: 10 / 12

3. Rotate the loader-valve lock rearward as shown
in
Figure 20 .
g020941
Figure 20
1. Loader-valve lock
4. Slide the loader-valve lock rearward until it
contacts the loader arm and attachment-tilt
levers.
5. Tighten the self-tapping bolts (1/4 x 5/8 inch) to
secure the loader valve lock.
6. Push forward on the loader arm and
attachment-tilt levers.
Note:
They should not move forward at all.
Note:
If they do, loosen the self-tapping bolts
(1/4 x 5/8 inch) and repeat steps 4 through 6 .
Important:
You will need to move the
levers rearward to engage or disengage the
loader-valve lock. The loader-valve lock
must touch the levers when it is down and
the levers are released.
9
Installing the CE-Compliant
Decals
Parts needed for this procedure:
1 CE-information decal
Procedure
Install the decals on the left side of the machine, near
the rear tire.
1. Clean the area where you will install the decal.
2. Dampen the area with water or mildly-soapy
water.
3. Peel the decal from the backing and install it in
place.
4. Squeegee across the surface of the decal,
starting at the center of the decal and working
toward the edges using overlapping strokes.
g249999
Figure 21
1. CE-information decal
10