Toro 78531, Operator'S Manual

Page: 7 / 32

Figure 6
1. Heat shield notch 3. Bottom of heat shield
2. Back of bagger
5. Slide the heat shield down until the holes align with the
bagger-bracket holes (
Figure 7 ).
Figure 7
Note:
Make sure to install the bagger bracket correctly,
as shown in Figure 8 .
Figure 8
1. Correct position 2. Incorrect position
6. Install the bagger bracket and heat shield to the rear of
the engine straps and rear bumper with 8 new bolts
(5/16 x 1 inch) and 8 new flange nuts (5/16 inch) as
shown in
Figure 9 .
7. Install the bagger bracket and heat shield to the side
of the engine straps, tailpipe guard and rear bumper
with 4 bolts, 4 washers and 4 flange nuts, previously
removed (
Figure 9 ).
Figure 9
1. Bagger bracket 5. Heat shield
2. Engine straps 6. Bolt (5/16 x 1 inch)
3. Rear bumper 7. Nut (5/16 inch)
4. Tailpipe guard
7