2.
Remove the 2 torx-head bolts and 2 nuts from
the left, rear guard (
).
Note:
Perform the step above on 1 side of the
machine, then the other.
g341515
Figure 8
1.
Left, rear guard
3.
Torx-head bolt
2.
Nut
3.
Loosely secure the left, upper bracket to the left,
rear guard and upper support using 2 hex-head
bolts (5/16 x 3-1/4 inches), 2 plain washers, 2
flange nuts (5/16 inch), 1 flange-head bolt (3/8 x
1-1/4 inches), and 1 locknut (3/8 inch) as shown
in
Note:
Perform the step above on 1 side of the
machine, then the other.
g341516
Figure 9
1.
Left, rear guard
5.
Flange-head bolt (3/8 x
1-1/4 inches)
2.
Flange nut (5/16 inch)
6.
Left, upper bracket
3.
Locknut (3/8 inch)
7.
Plain washer
4.
Upper support
8.
Hex-head bolt (5/16 x
3-1/4 inches)
4.
Loosely secure the lower support to the engine
plate using 2 carriage bolts (5/16 x 2-1/4 inches),
1 backer plate, and 2 flange nuts (5/16 inch) as
shown in
.
Note:
Perform the step above on 1 side of the
machine, then the other.
g341517
Figure 10
1.
Backer plate
3.
Lower support
2.
Carriage bolt (5/16 x 2-1/4
inches)
4.
Flange nut (5/16 inch)
5.
Tight all the fasteners.
11
