5
m–3591
1
2
3
4
Figure 3
1.
Height–of–cut lever
position
2.
Front mower wheels
parallel to mower
3.
Clevis pin
4.
Hairpin cotter
2. Lower the rear center wheel (if not already lowered),
using the following procedure:
A. Removing the hairpin cotter from the wheel rod
(Fig. 4).
B. Lifting the rear of the mower.
C. Pull the rod toward the outside of the mower, insert
the end of the rod into the hole in the height–of–cut
plate, and install the hairpin cotter into the second
hole of the wheel rod (Fig. 4).
m–3579
1
2
3
4
Figure 4
1.
Hairpin cotter
2.
Wheel rod
3.
Hole in height–of–cut plate
4.
Rear center wheel
3. Set the height of the two front mower wheels and turn
the wheels parallel to the mower by removing the
clevis pins and hairpin cotters, then turning and raising
or lowering the wheels until you can put the clevis
pins and hairpin cotters in the third position from the
top (Fig. 3).
4. Position the tractor and mower side by side, with the
mower on the right-hand side of the tractor.
5. Set the parking brake, raise the attachment lift, stop
the engine, and remove the ignition key.
6. If you have previously had a snowthrower, blade, or
tiller attached to the attachment lift, remove the two
clevis pins on each side of the attachment lift (Fig. 5).
