Toro 75744, Operator'S Manual

Page: 21 / 52

Adjusting the Height of Cut
Note:
The transport position is the highest
height-of-cut position or cutting height at 114 mm
(4-1/2 inches) as shown in
Figure 23 .
Height of cut is controlled by the lever located to the
right of the operating position (
Figure 23 ).
g296586
Figure 23
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
ARK
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers to 1 of the following
positions:
•
Upper hole—use this position with the mower
deck in the 63 mm (2-1/2 inches) and below
the height-of-cut positions (
Figure 24 ).
•
Lower hole—use this position with the mower
deck in the 76 mm (3 inches) and above the
height-of-cut positions (
Figure 24 ).
g019929
Figure 24
1. Anti-scalp roller 4. Upper hole—the mower
deck in the 63 mm (2-1/2
inches) and below the
height-of-cut positions
2. Lower hole—the mower
deck in the 76 mm (3
inches) and above the
height-of-cut positions 5. Bolt
3. Flange nut
21