Adjusting the Motion-Control
Neutral-Lock Pivot
You can adjust the flanged nut to obtain the desired
motion-control lever resistance when you move them to
the N
EUTRAL
-
LOCK
position. See
for adjustment
options.
1.
Loosen the jam nut.
2.
Tighten or loosen the flanged nut to the desired feel.
Note:
For more resistance, tighten the flanged nut.
Note:
For less resistance, loosen the flanged nut
3.
Tighten the jam nut.
Figure 89
1.
Flanged nut
2.
Jam nut
Hydraulic System
Maintenance
Servicing the Hydraulic
System
Hydraulic Fluid Type:
Toro
®
HYPR-OIL
™
500 hydraulic
fluid or Mobil
®
1 15W-50.
Important:
Use the fluid specified. Other fluids could
damage the hydraulic system.
Each Hydraulic System Fluid Capacity:
1.5 L (52 oz) per
side with filter change
Checking the Hydraulic Fluid
Service Interval:
Every 50 hours—Check the hydraulic-fluid
level.
1.
Position the machine on a level surface.
2.
Disengage the blade-control switch (PTO), move the
motion-control levers to the N
EUTRAL
-
LOCK
position,
and set the parking brake.
3.
Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
4.
Wait for the engine and hydraulic system to cool for
10 minutes.
Note:
The fluid level on the dipstick is incorrect if you
check the fluid when the machine is hot.
5.
Move the seat forward.
6.
Clean the area around the dipsticks of the hydraulic
system reservoirs (
7.
Remove 1 dipstick from the hydraulic reservoir (
8.
Wipe the dipstick off and thread the dipstick into the
reservoir.
9.
Remove the dipstick and look at the end (
Note:
If the fluid level is at the add mark, slowly pour
only enough fluid into the hydraulic reservoir to raise
the level to the full or
H
line.
Important:
Do not overfill the hydraulic units
with fluid, as damage may occur. Do not run the
machine with the fluid below the add mark.
10.
Install the dipstick.
11.
Repeat procedure for the opposite dipstick.
58
