Adjusting the Flow-Baffle-Cam
Locks
For Machines with Flow-Baffle Locks
Only
You can adjust the mower-discharge flow for different types
of mowing conditions. Position the cam locks and baffle to
achieve the best quality of cut.
Note:
Certain models have nuts and bolts in place of the
flow-baffle locks.
1.
Disengage the blade-control switch (PTO), move the
motion-control levers to the N
EUTRAL
-
LOCK
position,
and set the parking brake.
2.
Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3.
To adjust the cam locks, swing the lever up to loosen
the cam lock (
4.
Adjust the baffle and cam locks in the slots to the
desired discharge flow.
5.
Swing the lever back over to tighten the baffle and cam
locks (
).
6.
If the cam locks do not lock the baffle into place or it
is too tight, loosen the lever and then rotate the cam
lock. Adjust the cam lock until you achieve the desired
locking pressure.
Figure 30
Positioning the Flow Baffle
The following figures are only recommendations for use.
Adjustments vary by grass type, moisture content, and height
of grass.
Note:
If the engine power draws down and the mower
ground speed is the same, open up the baffle.
Position A
This is the full rear position. Use this position for the
following.
•
Short, light grass mowing conditions.
•
Dry conditions.
•
Smaller grass clippings.
•
Propelling grass clippings farther away from the mower.
Figure 31
26
