Changing the Engine Oil
Service Interval:
After the first 8 hours
Every 100 hours (more often in dirty or dusty
conditions).
Note:
Dispose of the used oil at a recycling center.
1.
Start the engine and let it run for 5 minutes.
Note:
This warms the oil so it drains better.
2.
Park the machine so that the rear is slightly lower than
the front to ensure that the oil drains completely.
3.
Disengage the PTO, move the motion-control levers to
the neutral-locked position, and set the parking brake.
4.
Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position (Figure 46).
G008804
G008793
1
2
3
4
4
5
Figure 46
5.
Slowly pour approximately 80% of the specified oil
into the filler tube and slowly add the additional oil to
bring it to the
Full
mark (Figure 47).
G008796
2
3
4
5
6
1
Figure 47
6.
Start the engine and drive to a flat area.
7.
Check the oil level again.
Changing the Engine-oil Filter
Service Interval:
Every 200 hours
Note:
Change the engine-oil filter more frequently when
operating conditions are extremely dusty or sandy.
1.
Drain the oil from the engine; refer to Changing the
Engine Oil (page 34).
2.
Change the engine-oil filter (Figure 48).
34
Summary of Contents for 74959
Page 62: ...Schematics G020788 Electrical Schematic Rev A 62 ...
Page 63: ...Notes 63 ...
