Toro 74959, Operator'S Manual

Page: 26 / 64

WARNING
Loading a unit onto a trailer or truck increases the
possibility of backward tip-over and could cause
serious injury or death.
• Use extreme caution when operating a unit on
a ramp.
• Ensure that the ROPS is in the up position while
using the seat belt when loading the machine.
Ensure that the ROPS will clear the top of an
enclosed trailer.
• Use only a single, full width ramp; Do not use
individual ramps for each side of the unit.
• If individual ramps must be used, use enough
ramps to create an unbroken ramp surface wider
than the unit.
• Do not exceed a 15 degree angle between ramp
and ground or between ramp and trailer or truck.
• Avoid sudden acceleration while driving unit up
a ramp to avoid tipping backward.
• Avoid sudden deceleration while backing unit
down a ramp to avoid tipping backward.
Figure 35
1. Trailer 3. Not greater than
15 degrees
2. Full width ramp 4. Full width ramp—side view
Transporting Machines
Use a heavy-duty trailer or truck to transport the machine.
Ensure that the trailer or truck has all necessary brakes,
lighting, and marking as required by law. Please carefully read
all the safety instructions. Knowing this information could
help you, your family, pets or bystanders avoid injury.
WARNING
Driving on the street or roadway without turn
signals, lights, reflective markings, or a slow
moving vehicle emblem is dangerous and can lead
to accidents causing personal injury.
Do not drive machine on a public street or roadway.
To transport the machine:
1. If using a trailer, connect it to the towing vehicle and
connect the safety chains.
2. If applicable, connect the trailer brakes.
3. Load the machine onto the trailer or truck.
4. Stop the engine, remove the key, set the brake, and
close the fuel valve.
5. Use the metal tie down loops on the machine to
securely fasten the machine to the trailer or truck with
straps, chains, cable, or ropes (Figure 36).
Figure 36
1. Traction unit tie down loops
26