G008952
Figure 22
Driving Backward
1.
Move the levers to the center, unlocked position.
2.
To go backward, slowly pull the motion control levers
rearward (Figure 23).
G008953
Figure 23
Stopping the Machine
To stop the machine, move the traction control levers to
neutral and move to locked position, disengage the power
take off (blade control switch (PTO), and turn the ignition
key to the off position.
Set the parking brake when you leave the machine; refer to
Setting the Parking Brake (page 16). Remove the key from
the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Adjusting the Height of Cut
Using the Transport Lock
The transport lock has 2 positions and is used with the deck
lift pedal. There is a lock position and a unlock position for
the transport position. The transport lock is used with the
deck lift pedal. Refer to Figure 24.
21
Summary of Contents for 74959
Page 62: ...Schematics G020788 Electrical Schematic Rev A 62 ...
Page 63: ...Notes 63 ...
