Troubleshooting
System Error Message
Status LED
System Actions
Issue Description
Recommended Corrective Action
Service the Engine Oil
Blink Red
Engine oil service is
due.
Replace the engine oil and filter.
Follow the reset procedure; refer to
Engine Oil (page 10)
.
Service the
Transmission Oil
Blink Red
Transmission oil
service is due.
Replace the transmission oil and
filter(s). Follow the reset procedure;
refer to
Hydraulic Trans Oil (page 10)
.
Low Oil Pressure
Blink Red
Safe Transport
Mode—engine limited
to Efficient mode and the
PTO is disengaged.
Engine oil pressure is
below limit.
Cycle the key switch to clear the
fault. Check the oil level. Contact an
Authorized Service Dealer.
Green
Single alarm chirp and
temperature display
flashes.
Engine temperature is
high.
Check the oil level. Clean debris from
the engine. Inspect the engine fan.
Contact an Authorized Service Dealer.
Engine Over
Temperature
Blink Red
Safe Transport
Mode—engine limited
to Efficient mode and the
PTO is disengaged.
Engine temperature
above limit.
Check the oil level. Clean debris from
the engine. Inspect the engine fan.
Contact an Authorized Service Dealer.
Fuel Low
Blink Red
Fuel level low.
Check the fuel level and add fuel as
necessary.
System Overvoltage
>16VDC
Blink Red
Disallow clutch
engagement/ Disengage
the clutch.
System voltage
excessive/ above
16 V.
Check the battery and engine
charging system. Contact an
Authorized Service Dealer.
System Voltage Low
Blink Red
System voltage below
12.3 V.
Check the battery and engine
charging system. Contact an
Authorized Service Dealer.
System Under
voltage<9VDC
Blink Red
Disallow clutch
engagement/ Disengage
clutch.
System voltage below
lower limit of 9 V.
Check the battery and engine
charging system. Contact an
Authorized Service Dealer.
Clutch Overcurrent
Blink Red
Safe Transport
Mode—engine limited
to Efficient mode and the
PTO is disengaged.
Clutch current is
above limit.
Cycle the key switch to clear the
fault. Check the PTO clutch condition
and the related wiring. Contact an
Authorized Service Dealer.
Clutch Reset Required
Alternating
green/orange
The PTO switch is
in the up/ engaged
position and the
module has latched
the clutch output Off.
Cycle the PTO switch to the O
FF
position and back to the O
N
position
to engage the clutch.
Clutch Output Fault
Blink Red
Clutch output short or
open.
If the clutch is stuck in the O
N
position,
discontinue use and contact an
Authorized Service Dealer. Check
the clutch connection and associated
wiring for an open circuit.
Engine MIL Errors
Blink Red
Engine ECU has
detected a fault.
See the engine owner’s manual for the
error description and troubleshooting
information.
15
