G010704
1
2
3
Figure 38
1.
Locknut (5/16 inch)
3.
Welded posts, right baffle
2.
Right baffle
4.
Carriage bolt
13. Install the fasteners removed previously at the front
holes in the discharge plate and forward hole in the
deck (Figure 37).
14. Locate the cut off baffle in the loose parts bag.
Remove the fasteners at the rear holes of the
discharge plate. Install the baffle at the side
discharge opening on the mower deck (Figure 39).
Figure 39
1.
Carriage bolt
3.
Cut off baffle
2.
Rear holes in the
discharge plate
4.
Locknut
15. Use the fasteners removed to secure the cut off
baffle to the deck.
16. Install the blades to the deck. Refer to the Installing
the Blades procedure in the
Maintenance
section for
more information.
Note:
Standard cutting blades will improve
discharge performance and can obtained from your
local authorized Toro dealer.
17. Install the mower as described in the Installing the
Mower procedure in the
Maintenance
section for
more information.
Using the Side Discharge
The mower has a hinged grass deflector that disperses
clippings to the side and down toward the turf.
DANGER
Without a grass deflector, discharge cover, or
complete grass catcher assembly mounted in
place, you and others are exposed to blade contact
and thrown debris. Contact with rotating mower
blade(s) and thrown debris will cause injury or
death.
•
Never remove the grass deflector from the
mower because the grass deflector routes
material down toward the turf. If the
grass deflector is ever damaged, replace it
immediately.
•
Never put your hands or feet under the mower.
•
Never try to clear the discharge area or mower
blades unless you move the blade control switch
(PTO) to the off position, rotate the ignition
key to off and remove the key.
•
Make sure the grass deflector is in the down
position.
32
Summary of Contents for 74920
Page 15: ...119 8986 1 Fuel 2 Full 3 Half 4 Empty 15 ...
Page 59: ...Schematics G014723 Wire Diagram Rev B 59 ...
Page 60: ...Notes 60 ...
Page 61: ...Notes 61 ...
