g017725
1
2
3
4
Figure 77
1.
Rod and spring assembly
partially installed
3.
Rod, short end, moved
behind mower bracket
2.
Loop end of the spring
installed into the notch in
the deflector bracket
4.
Short end, retained by
mower bracket.
5.
Secure the rod and spring assembly by twisting it so the
short end of the rod can be placed behind the front
bracket welded to the deck (Figure 77).
Important:
The grass deflector must be spring
loaded in the down position. Lift the deflector up
to test that it snaps to the full down position.
Cleaning
Washing the Underside of the
Mower
Service Interval:
After each use—Clean the mower housing.
Wash the underside of the mower after each use to prevent
grass buildup for improved mulch action and clipping
dispersal.
1.
Park the machine on a level surface and disengage the
blade control switch.
2.
Move the motion control levers outward to the neutral
lock position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3.
Attach the hose coupling to the end of the mower
washout fitting, and turn the water on high (Figure 78).
Note:
Spread petroleum jelly on the washout fitting
O-ring to make the coupling slide on easier and protect
the O-ring.
G010344
1
2
3
4
5
6
Figure 78
1.
Washout fitting locations
on 54 inch decks
4.
O-ring
2.
Washout fitting locations
on 48 inch decks
5.
Hose
3.
Washout fitting
6.
Coupling
4.
Lower the mower to the lowest height-of-cut.
50
Summary of Contents for 74920 TITAN ZX4820
