Toro 74806, Operator'S Manual

Page: 28 / 44

Figure 31
1. Battery
5. Battery hold-down
2. Terminal boot 6. Bolt and washer
3. Positive battery cable 7. Nut
4. Negative battery cable
Installing the Battery
1. Position the battery in the tray with the
terminal posts away from the control panel
(Figure 31).
2. Install the positive (red) battery cable to the
positive (+) battery terminal. Secure the cable
with a bolt (1/4 x 3/4 inch), washer (1/4 inch),
and nut (1/4 inch) (Figure 31).
3. Install the negative battery cable to the negative
(-) battery terminal. Secure the cable with
a bolt (1/4 x 3/4 inch), washer (1/4 inch), and
nut (1/4 inch) (Figure 31).
4. Slide the red terminal boot onto the positive
(red) battery post.
5. Secure the battery with the hold-down
(Figure 31).
Checking the Electrolyte Level
Battery electrolyte contains sulfuric acid
which is a deadly poison and causes severe
burns.
• Do not drink electrolyte and avoid
contact with skin, eyes or clothing. Wear
safety glasses to shield your eyes and
rubber gloves to protect your hands.
• Fill the battery where clean water is
always available for flushing the skin.
1. Tip the seat forward to see the battery.
2. Look at the side of the battery. The electrolyte
must be up to the Upper line (Figure 32).
Do not allow the electrolyte to fall below the
Lower line (Figure 32).
Figure 32
1. Vent caps
3. Lower line
2. Upper line
3. If the electrolyte is low, add the required
amount of distilled water; refer to Adding
Water to the Battery.
Adding Water to the Battery
The best time to add distilled water to the battery is
just before you operate the machine. This lets the
water mix thoroughly with the electrolyte solution.
1. Remove the battery from the tractor; refer to
Removing the Battery.
Important:
Never fill the battery with
distilled water while the battery installed in
the tractor. Electrolyte could be spilled on
other parts and cause corrosion.
2. Clean the top of the battery with a paper towel.
3. Remove the vent caps from the battery
(Figure 32).
4. Slowly pour distilled water into each battery
cell until the electrolyte level is up to the Upper
line (Figure 32) on the battery case.
Important:
Do not overfill the battery
because electrolyte (sulfuric acid) can
cause severe corrosion and damage to the
chassis.
5. Wait five to ten minutes after filling the battery
cells. Add distilled water, if necessary, until
the electrolyte level is up to the Upper line
(Figure 32) on the battery case.
6. Reinstall the battery vent caps.
28