Figure 15
1. Adjustment knobs
Adjusting the Motion
Control Levers
The motion control levers can be adjusted higher
or lower for maximum operator comfort.
1. Remove the 2 screws and curved washers
holding the control lever to the control arm
shaft (Figure 16).
2. Move the control lever to the next set of holes.
Secure the lever with the 2 screws and curved
washers. The cupped side of the washer should
be toward the control arm shaft (Figure 16).
3. Repeat the adjustment on the other control
lever.
Figure 16
1. Control lever
3. Curved washer
2. Screw
4. Control arm shaft
Pushing the Machine by
Hand
Important:
Always push the machine
by hand. Never tow the machine because
damage may occur.
To Push the Machine
1. Disengage the PTO and move the control
levers to the neutral locked position and apply
the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. Pull the two bypass levers up and push them
until the washer on the rod passes through the
slot. Push the levers down to lock them in
place (Figure 17).
4. Disengage the parking brake to push the
machine.
Figure 17
1. Position for pushing the
machine
2. Position for operating the
machine
To Operate the Machine
Pull each bypass lever up and pull them completely
out. Push the levers down (Figure 17).
Note:
The machine will not drive unless the
bypass levers are pulled out.
Side Discharge
The mower has a hinged grass deflector that
disperses clippings to the side and down toward
the turf.
18
Summary of Contents for 74806 TimeCutter ZX525
Page 7: ...Slope Chart 7 ...
Page 41: ...Schematics Electrical Schematic Rev A 41 ...
Page 42: ...Notes ...
Page 43: ...Notes ...
