Controls System
Maintenance
Adjusting the Motion-Control
Levers
If the motion-control levers do not align horizontally, adjust
the right side motion-control lever.
1.
Disengage the PTO, move the motion-control levers to
the neutral position, and set the parking brake.
2.
Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3.
Push the motion-control levers down out of the
N
EUTRAL
-
LOCK
position (
4.
Check if the right motion-control lever aligns
horizontally with the left motion-control lever (
Figure 68
1.
Left motion-control lever
3.
Check the horizontal
alignment here
2.
Right motion-control lever
in the Neutral-lock position
4.
Right motion-control lever
5.
To adjust the motion-control levers horizontally, you
must adjust the cam.
6.
Release the cushion from the rear of the machine.
7.
Loosen the nut holding the cam (
).
Figure 69
1.
Cam
2.
Nut
8.
Adjust the cam until it aligns with the left
motion-control lever and tighten the nut for the cam.
Note:
Moving the cam clockwise (in the vertical
position) lowers the handle; moving the cam
counterclockwise (in the vertical position) raises the
handle.
Important:
Ensure that the flat portion of the
cam does not go above a vertical position (right or
left); otherwise you may damage the switch.
9.
Repeat steps
through
for the left motion-control
lever.
47
Summary of Contents for 74504TE
Page 59: ...Schematics Electrical Schematic Rev A 59 ...
Page 60: ...Notes 60 ...
Page 61: ...Notes 61 ...
Page 62: ...Notes 62 ...