Toro 74504TE, Operator'S Manual, Page: 26 / 64

Adjusting the Flow Baffle
You can adjust the mower-discharge flow for different types
of mowing conditions. Position the cam lock and baffle to
provide the best quality of cut.
1. Disengage the PTO, move the motion-control levers to
the N
EUTRAL
-
LOCK
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. To adjust the baffle, loosen the nut ( Figure 28 ).
4. Adjust the baffle and nut in the slot to the desired
discharge flow and tighten the nut.
g012676
1 2
Figure 28
1. Slot 2. Nut
Positioning the Flow Baffle
The following figures are only for recommended use.
Adjustments vary by grass type, moisture content, and the
height of the grass.
Note:
If the engine power draws down, and the mower
ground speed is the same, open up the baffle.
Position A
This is the full, rear position (see Figure 29 ). Use this position
for the following:
•
In short, light grass mowing conditions
•
In dry conditions
•
Smaller grass clippings
•
Propels grass clippings farther away from the mower
G012677
Figure 29
26