3. After adjusting the height-of-cut, adjust the
rollers by removing the flange nut, bushing,
spacer, and bolt (Figure 19 , Figure 20 and
Figure 21 ).
Note:
The two middle rollers will not have a
spacer (Figure 20).
4. Select a hole so the anti-scalp roller is
positioned to the nearest corresponding
height-of-cut desired.
5. Install the flange nut bushing, spacer, and bolt.
Torque to 40-45 ft-lb (54-61 N•m) (Figure 19 ,
Figure 20 and Figure 21 ).
6. Repeat this adjustment on the other anti-scalp
rollers.
Figure 19
1. Anti-scalp roller
4. Flange Nut
2. Spacer
5. Bolt
3. Bushing
Figure 20
1. Anti-scalp roller
3. Flange Nut
2. Bushing
4. Bolt
Figure 21
1. Anti-scalp roller
4. Flange Nut
2. Spacer
5. Bolt
3. Bushing
26
Summary of Contents for 74280TE
Page 8: ...Slope Chart 8 ...
