Toro 7379, Operator'S Manual

Page: 16 / 56

complete. Failure to observe this precaution may result
in damage to the engine.
Check the operation of warning lights as follows:
•
Apply the parking brake.
•
Turn the ignition key to the On/Preheat position, but do
not start the engine. The coolant temperature, charge
indicator, and oil pressure lights should glow. If any light
does not function, either a bulb is burned out or there is a
malfunction in the system which must be repaired.
Fuel Gauge
The fuel gauge shows the amount of fuel in the tank. It
operates only when the ignition switch is in the On/Preheat
position (Figure 6). Red indicates low fuel level and blinking
red indicates near empty.
High-flow Hydraulics Switch (If so
equipped)
Turn on the switch to activate the high flow hydraulics (Figure
6).
Horn Button
Pressing the horn button activates the horn (Figure 6).
Tachometer
Registers the rpm of the engine (Figure 6 & Figure 7). White
triangle indicates the desired rpm for PTO operation (Figure
7).
Figure 7
1. Rpm of the engine 2. 3300 rpm for 540 rpm PTO
operation
Speedometer
Registers the ground speed of the vehicle (Figure 6). The
speedometer is in mph but can easily converted to kph. Refer
to Converting the Speedometer (page 46).
Power Point
Use the power point (Figure 6) to power optional 12 volt
electrical accessories.
Passenger Hand Hold
The passenger hand hold is located on the dashboard (Figure
8).
Figure 8
1. Passenger hand hold 2. Storage compartment
Seat Adjusting Lever
The seats can be adjusted fore and aft for operator comfort
(Figure 9).
Figure 9
1. Seat adjusting lever
16