Toro 72050 Wheel Horse 265H, Operator'S Manual

Page: 21 / 44

Operation
19
Using the Cruise Control
The cruise control is optional on some models. A 3
position: Set-Lock (spring loaded), On and
Off-Unlock dash switch (Fig. 15) controls the
engagement. Cruise control maintains the traction
control position without foot pressure. Cruise control
is intended for operation in the forward direction
only. Do not use cruise control in reverse.
Engaging the Cruise Control
1. Begin driving tractor: Refer to Driving Forward
or Backward, Page 16. While holding your foot
steady on the traction control, push the cruise
control switch (Fig. 15) to the “SET”–“LOCK”
position.
1
2
1641t
Figure 15
1. Lock-Set 2. Unlock-Off
2. This locks the traction control in position and
your foot can then be removed from the traction
control. A constant ground speed will be
maintained.
Disengaging the Cruise Control
1. While holding your foot steady on the traction
control, move the cruise control switch (Fig. 15)
to the “UNLOCK”–“OFF” position.
2. This unlocks the traction control and your foot
then operates the traction control.
3. For quick stops, just press on the brake pedal.
This automatically disengages the cruise control
and applies the brake at the same time.
Pushing the Machine by Hand
IMPORTANT: Always push the machine by
hand. Never tow the machine because
transaxle damage may occur.
To Push the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to “OFF” to stop the engine.
2. Move the drive control rod to the “PUSH”
position. This disengages the drive system and
allows the wheels to turn freely (Fig. 16).
To Operate the Machine
1. Move the drive control rod to the “OPERATE”
position (Fig. 16).
Note: The machine will not drive unless the
drive control rod is in the “OPERATE”
position.
1
2
3
M-4566
Figure 16
1. Operate position
2. Push position
3. Drive Control Rod