Toro 68138, Operator'S Manual, Page: 15 / 41

Shutting Off the Engine
1. Move the throttle between the F
AST
and S
LOW
positions.
2. Engage the parking brake.
3. Turn the key switch to the O
FF
position and
remove the key.
g038314
Figure 10
Operating the Hopper
Hopper capacity: 1134 kg (2,500 lb)
Know the load capacity of the machine and never
exceed it. This machine normally operates on uneven,
unpaved, bumpy, and/or inclined surfaces—adjust the
load accordingly.
1. Position the machine where you intend to dump
the load.
2. Dump the hopper by pushing the top of the
dump switch (
Figure 11 ).
3. Lower the hopper by pushing the bottom of the
dump switch (
Figure 11 ).
Note:
If you hold the bottom of the switch
0.2 to 1.3 seconds, the hopper fully lowers
automatically.
g038270
Figure 11
1. Dump the hopper. 2. Lower the hopper.
Removing Debris from the
Machine
1. Park the machine on a level surface, move
the motion-control levers to the N
EUTRAL
-
LOCK
position, engage the parking brake, and lower
the hopper.
2. Shut off the engine and remove the key. Allow
the engine to cool.
3. Clean the inside of the hopper using a hose.
Important:
Do not use a hammer to remove
material from the inside of the hopper; this
may cause damage to the machine.
4. Clean any debris from under the hopper.
5. Wipe away debris from the air cleaner.
6. Clean any debris buildup on the engine and in
the transmission with a brush or blower.
Important:
Blow out dirt rather than wash
it out. If you use water, keep it away from
electrical parts and hydraulic valves. Do not
use a high-pressure washer. High-pressure
washing can damage the electrical system
and hydraulic valves or deplete grease.
14
Go
to
Discount-Equipment.com
to
order
your
parts