Toro 68021HD, Operator'S Manual

Page: 39 / 44

Aligning the Pulleys
1. Remove the divider plate; refer to Removing the
Divider Plate (page 27) .
2. Place a straightedge across the face of the engine pulley
and the idler pulley (
Figure 61 ).
G020015
5 3 6
1 2
4
Figure 61
1. Engine pulley 4. Idler shaft
2. Idler pulley 5. Locknut
3. Straightedge 6. Setscrew
Note:
Both pulleys must be aligned flush with the
straightedge.
3. If the pulleys are not aligned do the following:
A. Move the clutch lever to the O
FF
position.
B. Loosen the locknuts and setscrews that secure the
idler pulley to the idler shaft (
Figure 61 ).
C. Using a soft-face mallet, tap the idler pulley
forward or backward along the idler shaft until
the engine pulley and the idler pulley are aligned
to the straight edge (
Figure 61 ).
D. Tighten the setscrews and locknuts that secure the
idler pulley to the idler shaft (
Figure 61 ).
4. Install the divider plate; refer to Installing the Divider
Plate (page 27) .
Cleaning
Cleaning the Machine
Regular cleaning and washing with mild detergent and water
increases the life span of the machine. Clean the machine
after each use before the dirt hardens.
Remove dirt and grime from the external parts of the entire
machine, especially the engine. Clean dirt and concrete
materials from the outside of the engine.
Ensure that the fuel cap and the oil-fill cap/dipstick are
secure to avoid getting water in the engine.
Use care when using a high-pressure sprayer because it can
damage safety decals, instruction signs, and the engine.
Important:
Lubricate the trunnions after cleaning; refer
to Lubricating the Bearings and Seals (page 28) .
39