Connecting the Lighting Wire Harness
Connect the electrical plug of the machine with the electrical
plug of the tow vehicle as shown in Figure 20.
G020828
Figure 20
Note:
The machine uses a standard 4-flat plug. If your tow
vehicle has a different type of plug, obtain an adapter from an
automotive parts store.
Important:
Routinely check the lights to ensure that
they are working properly, including the tail lights, brake
lights, and each appropriate turn signal.
Checking the Lights
•
Ensure that the tail lights of the machine illuminate when
you turn on the headlights of tow vehicle.
•
Ensure that the brake lights of the machine illuminate
when you press the brake pedal of the tow vehicle.
•
Ensure that the appropriate turn signal flashes when you
operate the corresponding turn signal of the tow vehicle.
Extending the Axle
WARNING
The machine is not stable when towing it with the
axle in the narrow position.
Tow the machine with the axle in the wide position.
Important:
Adjust the axle to the narrow position only
to move the machine through a narrow access point,
such as the gate of a fence or the doorway of a building.
Preparing to Change the Axle Width
1.
Move the machine to a level job-site surface.
2.
Disconnect the machine from the tow vehicle.
3.
Chock the tires.
4.
Ensure that the drum is empty and in the mix position
(upright).
5.
Ensure that the drum latch is engaged and that the
drum does not rotate toward the dump position.
Adjusting the Axle Width
WARNING
Mechanical or hydraulic jacks may fail to support
the machine and cause serious injury.
Use jack stands when supporting the machine.
1.
Align a jack with an adequate lift height and weight
capacity under the axle; refer to Specifications (page
11).
2.
Lift the machine until the tires are off the ground.
3.
Use a jack stand at each support point on the rear
frame extension (Figure 21).
G020476
1
Figure 21
1.
Support point (2)
4.
Remove the bolts and nuts that secure the inner axle to
the outer axle (Figure 22).
1
2
3
4
3
5
6
5
G020020
Figure 22
1.
Wide position (towing)
4.
Nut (narrow position)
2.
Narrow position
5.
Bolt (wide position)
3.
Nut (wide position)
6.
Bolt (narrow position)
5.
Align the inner axle to the desired position as follows:
15
Summary of Contents for 68012C
Page 33: ...Schematics G021587 Electric Motor Schematic Rev A 33 ...
Page 34: ...Notes 34 ...
Page 35: ...Notes 35 ...
