Installing the Divider Plate
1.
Guide the divider plate into position against the front
cowl.
Note:
Start with the divider plate rotated slightly
counterclockwise, and then rotate it clockwise while
lowering it into position.
Ensure that the divider plate is not backward.
G021586
Figure 31
2.
Align the bolt holes in the divider plate and the front
cowl.
3.
Install each of the 4 bolts, and hand-tighten them to
prevent cross-threading.
4.
Tighten the bolts with a wrench until they are secure.
Lubrication
Lubricating the Bearings and
Seals
Service Interval:
After each use—Lubricate the trunnions.
Monthly—Lubricate the pillow-block bearings.
Note:
The pillow-block bearings are inside the
cowl—remove the divider plate to access them; refer to
Removing the Divider Plate (page 22).
Grease type:
#2 general-purpose lithium-based grease.
1.
Clean around each grease fitting with a rag and lift the
plastic cap off the grease fitting (Figure 32).
1
2
3
g021 101
1
2
3
Figure 32
1.
Pillow-block bearings
3.
Front trunnion
2.
Rear trunnion
23
Summary of Contents for 68012C
Page 33: ...Schematics G021587 Electric Motor Schematic Rev A 33 ...
Page 34: ...Notes 34 ...
Page 35: ...Notes 35 ...
