Toro 60in Bagger Kit, Operator'S Manual

Page: 11 / 20

4. Lift the bagger top and install the bags by sliding
the bag frame hooks onto the retaining brackets
(
Figure 14 ).
1
2
3
4
g033032
Figure 14
1. Bag 3. Retaining bracket
2. Bagger frame 4. Bag frame hook
5. Lower the bagger top onto the bags ( Figure 15 ).
g033030
Figure 15
6. Secure the hood with the latch ( Figure 15 ).
7. Install the upper bagger tube by inserting the
curved end into the opening in the bagger top.
Note:
Make sure that the flared end with the
retention post is pointing down and forward in
preparation to be mated with the finishing kit.
7
Installing the High-Lift
Blades
Parts needed for this procedure:
3 High-lift blade
Procedure
Refer to the Operator’s Manual for the machine to
remove the existing blades and install the high-lift
blades.
8
Installing the Chute
Parts needed for this procedure:
1 Curved baffle
1 Locknut (5/16 inch)
1 Hand knob
1 Washer
1 Chute
Procedure
WARNING
An uncovered discharge opening could allow
the lawn mower to throw objects toward you
or bystanders, resulting in serious injury.
Also, contact with the blade could occur.
Never operate the lawn mower unless you
install a cover plate, a mulch plate, or a grass
chute and catcher.
Never operate the mower with the discharge opening
uncovered. Always use a discharge cover, mulch
cover, or bagging chute when operating the mower
deck.
1. Remove fasteners that secure the deflector
assembly to the mower deck (
Figure 16 ).
Note:
Retain all fasteners.
11