Toro 60in Bagger Kit, Operator'S Manual

Page: 8 / 20

3
Installing the Attachment
Mount
Parts needed for this procedure:
1 Stabilizer bracket
2 Carriage bolt (5/16 x 3/4 inch)
4 Locknut (5/16 inch)
2 Self-tapping screw (5/16 x 3/4 inch)
2 Bolt (5/16 x 1 inch)
1 Pivot frame
2 Hairpin cotter
2 Rod
2 Washer
1 Draw-bar decal
Procedure
1. Install the stabilizer bracket to the engine guard
using 2 carriage bolts (5/16 x 3/4 inch) and 2
locknuts (5/16 inch) as shown in
Figure 6 .
g203564
Figure 6
1. Stabilizer bracket 3. Locknut (5/16 inch)
2. Carriage bolt (5/16 x 3/4
inch)
2. Install the pivot frame to the machine frame as
shown in
Figure 7 . Ensure that you push the
pivot frame up until it is tight against the bottom
of the engine guard. Loosely secure the pivot
frame to the machine frame using 2 bolts (5/16 x
1 inch) and 2 locknuts (5/16 inch).
g203563
Figure 7
1. Machine frame 4. Bolt (5/16 x 1 inch)
2. Locknut (5/16 inch) 5. Pivot frame
3. Hole
3. Secure the pivot frame to the bottom of the
machine frame using 2 self-tapping screws (5/16
x 3/4 inch) as shown in
Figure 8 .
g203566
Figure 8
1. Self-tapping screw (5/16 x
3/4 inch) 2. Pivot frame
4. Tight the 2 bolts (5/16 x 1 inch) and 2 locknuts
(5/16 inch) from step
2 .
5. Attach the draw bar decal 1.3 cm (1/2 inch) to
the left of the attachment mount (
Figure 9 ).
8