Toro 60213, Operator'S Manual

Page: 20 / 52

g020019
Figure 21
1. Support point (2)
7. Remove the bolts and nuts that secure the inner
axle to the outer axle (
Figure 22 ).
g020020
Figure 22
1. Wide position (towing) 4. Nut—narrow position
2. Narrow position 5. Bolt—wide position
3. Nut—wide position 6. Bolt—narrow position
8. Align the inner axle to the desired position as
follows:
•
Slide each side of the axle inward to the
narrow position (
Figure 22 ).
•
Slide each side of the axle outward to the
wide (tow) position (
Figure 22 ).
9. Secure the axle with the bolts and nuts removed
previously (
Figure 22 ) and torque them to 87
N∙m (64 ft-lb).
Preparing to Use the
Machine
1. Park the machine on a level surface and
disconnect the machine from the tow vehicle.
2. Ensure that all guards and paddles are in place
and in good condition.
3. Perform all daily maintenance procedures
prescribed in
Maintenance (page 27) .
4. Chock the front and back of the tires to prevent
the machine from moving.
5. Move the drum to the upright position and lock it.
Opening the Cowl
g035134
Figure 23
20