Toro 44701, Operator'S Manual

Page: 27 / 44

Figure 46
1. Rubber seal 3. Handheld remote
2. Steel gasket 4. 4 AA batteries
4. Remove the discharged batteries and properly dispose
in accordance with local regulations.
5. Plug each fresh battery into a terminal cradle observing
proper polarity. (If the batteries are improperly
installed, the unit will not be damaged, but it will fail
to operate.) The cradle is embossed with polarity
markings for each terminal (
Figure 46 ).
6. If you accidentally removed the rubber seal and the
steel gasket, replace them carefully into the channel in
the handheld remote (
Figure 46 ).
7. Replace the cover and secure it with the 6 screws
removed previously (
Figure 46 ) and torque them to 1.5
to 1.7 N-m (13 to 15 in-lb).
8. Install the handheld remote into the magnetic remote
bracket, slide the halves together to secure the remote,
and tighten the bolt in the magnet (
Figure 45 ).
Caring for the Handheld Remote
Though the handheld remote is rugged, care should be taken
not to drop the unit onto hard surfaces. To clean it, use a
soft cloth moistened with water or a mild cleaning solution
to wipe it paying particular attention to avoid scratching the
LCD screen.
Associating the Handheld Remote with
the Base
The factory initially associates the remote to the base allowing
them to communicate; however, there may be instances in the
field when you must reassociate a remote and a base unit,
as follows:
1. Press the E-Stop button to remove power from the
base unit and make sure the handheld is off.
2. Stand near the base unit in clear line of sight.
3. Simultaneously press and continue to hold the
O
N
/O
FF
and the A
LL
S
TOP
buttons.
+
The handheld remote goes through its initialization
screens and settles on
ASSOC PENDING .
4. Continue to hold both buttons and then quickly
release them when
ASSOC ACTIVE is displayed
(approximately 4 seconds).
The display will show PRESS STORE .
5. Press and hold the S
TORE
button.
The remote displays POW UP BASE .
6. While continuing to hold the S
TORE
button, pull out
on the E-S
TOP
button to power up the base unit.
The handheld remote will associate (link) with the base
unit. Upon success, the display will show
ASSOC
PASS.
7. Release the S
TORE
button.
Important:
If the display shows ASSOC EXIT, the
association failed.
Note:
The Handheld Remote and Base Unit link can be
viewed by holding down the A
LL
S
TOP
and O
PTION
S
TOP
buttons at the same time.
The display will cycle and indicate the selected channel and
the ID of the Base Unit.
+
27