Electrical System
Maintenance
Replacing the Fuses
The fuse block for the electrical system is located
beneath the operator's seat (
g034159
Figure 79
1.
Open slot
9.
Open slot
2.
Work light
10.
Open slot
3.
Ignition
11.
InfoCenter
4.
Tec Logic
12.
Tank spray
5.
Tec power
13.
Cruise control
6.
Tec power
14.
USB power
7.
Extra fuse slot
15.
Boom and headlight
8.
Boom control
16.
Tec power
Servicing the Battery
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to
the State of California to cause
cancer and reproductive harm.
Wash
hands after handling.
Always keep the battery clean and fully charged. Use
a paper towel to clean the battery and battery box. If
the battery terminals are corroded, clean them with
a solution of 4 parts water and 1 part baking soda.
Apply a light coating of grease to the battery terminals
to prevent corrosion.
Voltage: 12 V with 690 A (cold cranking) at 0°F
(-18°C).
Removing the Battery
1.
Position the sprayer on a level surface, engage
the parking brake, shut off the spray pump, shut
off the engine, and remove the key.
2.
Remove the battery cover and disconnect the
negative (black) ground cable from the battery
post (
).
g014029
Figure 80
1.
Battery cover
3.
Buckle
2.
Strap
61
Summary of Contents for 41393
Page 88: ...Schematics g034336 Sprayer System Schematic Rev DWG 131 9559 Rev A 88...
Page 89: ...Notes...
Page 90: ...Notes...
