Toro 41393, Operator'S Manual

Page: 40 / 92

•
If the pressure gauge indicates 689 kPa (100
psi), the agitation-bypass valve is properly
calibrated.
•
If the pressure gauge indicates differently,
continue to the next step.
10. Adjust the agitation-bypass valve ( Figure 41 )
on the backside of the agitation valve until the
sprayer system pressure indicated on the gauge
indicates 689 kPa (100 psi).
g191362
Figure 41
1. Actuator (agitation valve) 2. Agitation-bypass valve
11. Turn the spray-pump switch to the O
FF
position.
12. Move the throttle lever to the I
DLE
/S
LOW
position
and turn the key switch to the O
FF
position.
Locating the Spray Pump
The spray pump is located near the back of the tank
on the left side (
Figure 42 ).
g194233
Figure 42
1. Spray pump
Hauling the Machine
•
Use full-width ramps for loading the machine onto
a trailer or truck.
•
Tie the machine down securely.
Transporting the Sprayer
For moving the sprayer long distances, use a trailer.
Secure the sprayer to the trailer. Also, ensure that the
outer boom sections are tied down and secure.
Figure
43 and Figure 44 illustrate the tie-down points.
g002210
Figure 43
1. Tie-down points
40