g032530
Figure 26
1.
Filler cap
3.
Spigot
2.
Fresh-water tank
Filling the Spray Tank
Important:
Ensure that the chemicals you use are
compatible with Viton™ (see the manufacturer's
label; it should indicate if it is not compatible).
Using a chemical that is not compatible with Viton
will degrade the O-rings in the sprayer, causing
leaks.
Important:
The tank-volume markings are for
reference only and cannot be considered accurate
for calibration.
Important:
After filling the tank for the first time,
check the tank straps for any play. Tighten as
necessary.
1.
Stop the machine on a level surface, shut off the
engine, and engage the parking brake.
2.
Determine the amount of water needed to mix
the amount of chemical you need as prescribed
by the chemical manufacturer.
3.
Open the tank cover on the spray tank.
Note:
The tank cover is located in the center
of the top of the tank. To open it, turn the front
half of the cover counterclockwise and swing it
open. You can remove the strainer under the
tank cover and clean the strainer.
4.
Assemble the fill hose to the quick disconnect
fitting of the anti-siphon fill receptacle.
5.
Add 3/4 of the required water to the spray tank
(
).
Important:
Always use fresh, clean water in
the spray tank. Do not pour concentrate into
an empty tank.
g191616
Figure 27
6.
Start the engine, engage the parking brake, set
the spray-pump switch to the O
N
position, and
move the throttle lever to
HIGH IDLE
.
7.
Set the agitation switch to the O
N
position.
Important:
Prior to introducing wettable
powders into any Toro Spray System mix
the powders in a suitable container with
sufficient fresh water to create a free flowing
slurry. Failure to do so may result in
chemical deposits on the bottom of the tank,
degraded agitation, clogging of filters, and
improper application rates.
Toro recommends using the approved
Eductor Kit for this machine. Contact your
Authorized Toro Dealer for more information.
8.
Add the proper amount of chemical concentrate
to the tank, as directed by the chemical
manufacturer.
9.
Add the remaining water to the tank, remove the
fill hose, and close the tank cover.
Note:
To seal the tank, close the cover and
rotate the front half clockwise.
31
Summary of Contents for 41393
Page 88: ...Schematics g034336 Sprayer System Schematic Rev DWG 131 9559 Rev A 88...
Page 89: ...Notes...
Page 90: ...Notes...
