g001011
Figure 10
The machine should move rearward. If the
machine does not move or moves forward,
complete the following:
A.
Release the traction lever and shut off the
machine; refer to
(page 22)
.
B.
Disconnect the trunnion from the
speed-selector lever.
C.
Turn the trunnion downward (clockwise) on
the speed-control rod.
D.
Connect the trunnion to the speed-selector
lever.
4.
Release the traction lever.
5.
Move the speed selector to Position 1; refer to
Operating the Speed Selector (page 19)
.
6.
Squeeze the left (traction) lever to the handgrip
(
).
The machine should move forward. If the
machine does not move or moves rearward,
complete the following:
A.
Release the traction lever and shut off the
machine.
B.
Disconnect the trunnion from the
speed-selector lever.
C.
Turn the trunnion upward (counterclockwise)
on the speed-control rod.
D.
Connect the trunnion to the speed-selector
lever.
7.
If you made any adjustments, repeat this
procedure until no adjustments are required.
Important:
If the machine moves when the
traction lever is in the released position, check the
traction cable; refer to
the Traction Cable (page 24)
or take the machine
to an Authorized Service Dealer for service.
Product Overview
g361064
Figure 11
1.
Handgrip (2)
10.
Chute deflector
2.
Auger/impeller lever
11.
Discharge chute
3.
Lock switch
12.
Scraper
4.
Speed-selector lever
13.
Auger
5.
Handwarmer switch
14.
Skid (2)
6.
Quick Stick
®
discharge-chute control
15.
Control panel
7.
Traction lever
16.
Secondary
battery-compartment
lid
8.
Main battery-compartment
lid
17.
Snow-cleanout tool
9.
Electric-start key
18.
Headlight
14
