g215482
g214716
Figure 17
Inspecting the Throwing
Edges
Service Interval:
Yearly—Inspect the throwing edges
and have an Authorized Service
Dealer replace the throwing edges
and scraper if necessary.
Before each session, inspect the throwing edges
for wear. When a throwing edge has worn down to
the wear-indicator hole, have an Authorized Service
Dealer replace the throwing edges (
).
g030128
Figure 18
1.
The wear-indicator hole
is intact; you do not need
to replace the throwing
edges.
2.
The wear-indicator hole
is exposed; replace both
throwing edges.
Changing the Engine Oil
Service Interval:
After the first 2 hours
Yearly
If possible, run the engine for a few minutes before
changing the oil to warm it. Warm oil flows better and
carries more contaminants.
Engine Oil Specifications
Engine oil capacity
0.60 L (20 fl oz)
Oil viscosity
Refer to
.
API service classification
SJ or higher
1.
Move the machine to a level surface.
2.
Place an oil-drain pan under the oil-drain plug,
remove the oil-drain plug, and tip the machine
backward and drain the used oil in the oil-drain
pan (
13
Summary of Contents for 38720
Page 18: ...Notes ...
Page 19: ...Notes ...
