Toro 38701, Operator'S Manual

Page: 26 / 36

Adjusting the Broom Drive Cable
1. Loosen the jam nut ( Figure 40 ).
g325107
Figure 40
1. Adjuster tube 3. Spring-tension adjuster
2. Jam nut 4. Spring
2. Rotate the spring-tension adjuster until you
measure a 1.5 mm (1/16 inch) gap between the
frame and the broom clutch arm (
Figure 40 and
Figure 41 ).
g326890
Figure 41
1. 1.5 mm (1/16 inch) gap
3. Broom clutch arm
2. Frame
3. Tighten the jam nut ( Figure 40 ).
4. Install the belt cover; refer to Installing the Belt
Cover (page 26) .
Important:
If the broom cable is properly adjusted
but a problem remains, contact your Authorized
Service Dealer.
Belt Maintenance
Removing the Belt Cover
1. Loosen the 2 flange-head screws that secure
the belt cover to the machine (
Figure 42 ).
g325103
Figure 42
1. Screw 2. Belt cover
2. Remove the cover from the machine.
Installing the Belt Cover
1. Align the slots in the belt cover with the 2
flange-head screws (
Figure 43 ).
g325103
Figure 43
2. Assemble the belt cover onto the machine
(
Figure 43 ).
3. Tighten the flange-head screws.
26