Note:
For easier installation, look down through the
opening in the speed selector (Figure 13).
G000988
1
Figure 13
1. Speed selector
4. Installing the Chute Control
Rod
1. Unwrap the Quick Stick and rotate it so that it is upright
and in the center.
2. Hold the blue trigger cap down and pull the lever fully
rearward.
Note:
The discharge chute and de
fl
ector should face
forward. If they do not, hold the blue trigger cap
down (but do not move the Quick Stick) and rotate the
discharge chute until they do.
3. Align the
fl
attened back end of the long chute control
rod with the
fl
attened front end of the short rod
that extends from the control panel so that they nest
together (Figure 14).
1
2
G000989
Figure 14
1. Short rod
2. Long chute control rod
4. Insert the front end of the rod into the opening in the
back of the chute gear cover until it slides into the chute
gear (Figure 15).
G000990
Figure 15
5. Align the holes in the nested ends of the rods and insert
2 carriage bolts (in the loose parts bag) through the
short rod from the left side of the snowthrower (from
the operating position).
6. Insert the cable clip that supports the de
fl
ector cable
onto the forward carriage bolt, and secure the carriage
bolts with locknuts from the loose parts bag (Figure 16).
G000991
1
2
Figure 16
1. Cable clip
2. De
fl
ector cable
7. Hold the blue trigger cap down and rotate the Quick
Stick in a circle to ensure that the chute and de
fl
ector
operate smoothly.
8
