![background image](http://html.mh-extra.com/html/toro/38611/38611_operators-manual_1134064003.webp)
3
3329-784
•
To unclog the discharge chute, stay in the
operating position and release the left hand
(traction) lever. While running the auger/impeller,
push down on the handles to raise the front of the
snowthrower a few inches (centimeters) off the
pavement. Then lift the handles quickly to bump
the front of the snowthrower on the pavement.
Repeat if necessary until a stream of snow comes
out the discharge chute.
•
If you cannot unclog the discharge chute by
bumping the front of the snowthrower, stop the
engine, wait for all moving parts to stop, and
use a stick; never use your hand.
•
Do not wear loose-fitting clothing that could get
caught in moving parts.
•
If a shield, safety device, or decal is damaged,
illegible, or lost, repair or replace it before
beginning operation.
•
Do not smoke while handling gasoline.
•
Do not touch the engine while it is running or
soon after it has stopped because the engine
may be hot enough to cause a burn.
•
When storing the snowthrower for more than
30 days, drain the fuel from the fuel tank to
prevent a potential hazard. Store fuel in an
approved fuel container. Remove the key from
the ignition switch before storing the
snowthrower.
•
Purchase only genuine Toro replacement parts
and accessories.
Sound Pressure
This unit has a maximum sound pressure level at the
operator’s ear of 92 dBA, based on measurements of
identical machines per Directive 98/37/EC.
Sound Power
This unit has a guaranteed sound power level of
108 dBA, based on measurements of identical
machines per Directive 2000/14/EC.
Vibration
This unit does not exceed a hand/arm vibration level
of 7.0 m/s
2
, based on measurements of identical
machines per Directive 98/37/EC.
Read and understand the contents of this manu
al before operating the snowthrower. Become
familiar with all controls and know how to stop
the engine quickly.
Before Operating
Operator's
Position
472
Caution: Improper use may result
in loss of fingers, hands, or feet.
impeller close to the
opening.
The lowspeed auger
has a moving pinch
point close to the
opening.
There is a highspeed
m-6936