Figure 3
1.
Axle pin (2)
3.
Handle
2.
Cap screw and curved
washer (4)
3. Thread a flange nut (not the flange locknut) with the
flange down onto the traction rod attached to the
left side of the handle (Figure 4).
Figure 4
1.
Traction rod
3.
Lower traction rod loop
2.
Flange nut
4.
Flange locknut
4. Position the left side of the handle against the side
of the machine and insert the end of the traction rod
through the lower traction rod loop Figure 4).
5. Align the holes in the left side of the handle with
the holes in the left side plate, and secure the handle
with 2 cap screws and Belleville washers until they
are finger tight (Figure 3).
Note:
The concave side of the Belleville washer
goes against the outside of the handle.
6. Align the holes in the right side of the handle with
the holes in the right side plate, and secure the
handle with 2 cap screws and Belleville washers until
they are finger tight.
7. Ensure that the handles are at the same height, then
tighten the handle fasteners securely.
8. Slide the wheels outward and insert each axle pin
through the hole in each wheel hub and through the
outer
hole of the axle (Figure 5).
Figure 5
1.
Axle pin
2.
Hole in wheel hub and
outer axle hole aligned
Note:
If you install tire chains (optional), you must
install the axle pins through the
outer
axle holes.
2
Installing the Speed Selector
Rod
Parts needed for this procedure:
1
Speed selector rod
1
Cotter pin
1
Flat washer
Procedure
1. Pull the speed selector arm (Figure 6) to the most
outward position.
8
