Adjusting the Discharge Chute
Latch
If the discharge chute does not lock into the desired
position or does not unlock so that you can move it to
another position, adjust the discharge chute latch.
1. Remove the fastener on the gear cover (Figure 52),
lift the front of the cover up, and slide it back and
out of the way.
Figure 52
2. Loosen the bolt on the cable clamp (Figure 53).
Figure 53
1.
Cable conduit
2.
Cable clamp
3. Grasp the cable conduit and move it toward the front
of the machine until the discharge chute latch fully
engages the gear teeth (Figure 53 and Figure 54).
Figure 54
1.
Discharge chute latch
2.
Gear teeth
Note:
The latch is spring loaded and will naturally
move into the teeth of the gear (Figure 54).
4. Remove any slack in the cable by pulling the cable
conduit rearward.
5. Tighten the bolt on the cable clamp.
6. Install and secure the gear cover.
Replacing the Drive Belts
If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, go
to www.Toro.com for additional service information or
have an Authorized Service Dealer replace the belt.
Replacing the Headlight Bulb
Models 38633, 38637, 38639, and 38657 only
Use a
GE 892 16W halogen light bulb.
Do not touch
the bulb with your hands or allow dirt or moisture to
come into contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure 55).
Figure 55
2. Turn the base of the bulb counterclockwise until it
stops (Figure 56).
Figure 56
3. Remove the bulb straight out from the back of the
headlight (Figure 57).
24
Summary of Contents for 38597
Page 29: ...Notes 29 ...
Page 30: ...Notes 30 ...
