Toro 38587, Operator'S Manual

Page: 5 / 16

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
No parts required
–
Unfold the handle.
Discharge chute 1
Chute handle 1
Phillips head screws 3
Washers 3
2
Locknuts 3
Install the discharge chute.
1
Unfolding the Handle
No Parts Required
Procedure
1. Loosen the handle knobs, pull out the “U”-shaped
handle locks until you can move the handle freely,
and rotate the handle to the operating position
(Figure 4).
Figure 4
1. “U”-shaped handle lock (2) 2. Handle knobs
2. Insert the end of the “U”-shaped handle lock into
the open hole in the handle and tighten the handle
knobs until they are snug (Figure 5).
Figure 5
Important:
Ensure that you do not pinch or
kink the control cable (Figure 6).
Figure 6
1. Control cable
5