Figure 36
1.
Drive belt cover
6.
Drive belt
2.
Bolt (3)
7.
Rotor shaft
3.
Rotor pulley bolt
8.
Brake spring (unhook from
idler arm here)
4.
Curved washer
9.
Idler pulley
5.
Rotor pulley
10.
Engine pulley
2. Unhook the brake spring from the idler arm to
release the belt tension (Figure 36).
3. Remove the screw and curved washer that holds the
rotor pulley (Figure 36).
4. Remove the rotor pulley and the drive belt
(Figure 36).
5. Install the new drive belt, routing it as shown in
(Figure 37).
Figure 37
1.
Brake spring (install on
idler arm here)
3.
Engine pulley
2.
Idler pulley
4.
Rotor pulley
Note:
Route the new drive belt first around the
engine pulley, then the idler pulley, and finally around
the loose rotor pulley positioned just above the rotor
shaft (Figure 36).
6. Install the rotor pulley onto the rotor shaft
(Figure 36).
7. Install the curved washer and the rotor pulley bolt
and tighten them securely (Figure 36).
Note:
The concave side of the curved washer goes
against the outside of the pulley.
8. Install the brake spring onto the idler arm (Figure 37).
9. Install the drive belt cover with the bolts you
removed in step 1.
Note:
Ensure that the drive belt is properly adjusted
and operating; refer to Checking the Control Cable
and Adjusting the Control Cable.
16
Summary of Contents for 38453
Page 18: ...Notes 18 ...
