Stopping the Machine
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the key and engage the
parking brake when leaving the machine
unattended.
1.
Move the motion-control levers to neutral and
engage the parking brake.
2.
If running, shut off the spray pump.
3.
If running, shut off the impeller motor.
4.
Shut off the engine and remove the key.
5.
If you are parking the machine on an incline,
chock the tires in addition to engaging the
parking brake.
Driving Across Hills
The caster-wheel lock allows the operator to lock the
front caster wheels in the forward position to increase
side hill stability.
•
Press and hold the caster wheel-lock pedal to lock
the caster wheels in the straight position.
•
Release the caster wheel-lock pedal to unlock the
caster wheels, and allow the machine to freely
turn.
The Display
Refer to the
User’s Manual
for the display of the
following information:
Display Information Types
•
Time of day
•
Stopwatch
•
Ground speed
•
Odometer
•
Battery voltage
•
Hour meter (internal)
•
Air temperature
•
Display battery voltage
Display Operation Controls
•
User interface and buttons
•
Backlighting
•
Data Reset
Setup Mode
•
Units of measure
– Distance—KM/H (kilometers per hour) or M/H
(miles per hour)
– Temperature—°C or °F
•
Clock format and time of day
•
Low voltage caution and warning
Maintenance
Changing the display battery
Operating the Spreader
CAUTION
Chemicals are hazardous and can cause
personal injury.
•
Read the chemical manufacturer’s
directions on the label before handling
the chemicals; follow all manufacturer
recommendations and precautions.
•
Keep chemicals away from your skin.
Should contact occur, wash the affected
area thoroughly with soap and clean water.
•
Wear eye protection, gloves, and any other
protective equipment recommended by the
chemical manufacturer.
Use the spreader to disperses free-flowing granular
materials such as grass seed, fertilizer, ice melt, etc.
When you use the spreader, first fill the hopper, then
24
