Toro 34215, Operator'S Manual

Page: 28 / 80

g027304
Figure 28
1. Locking sleeve 4. Drop-rate cam
2. Gate cable 5. Rate-gate linkage
3. Ball stud
2. Pull the cable off the ball stud ( Figure 28 ).
3. Rotate the drop-rate cam past position-9 so
that the slot in the cam aligns with the linkage
(
Figure 28 ).
4. Fully push the rate-gate linkage rearward ( Figure
28 ).
5. If there is material in the hopper allow the
material to pour into a shallow pan; when the
hopper is empty, remove the pan.
Connecting the Rate-Gate Linkage
1. Pull the linkage out until it clears the drop-rate
cam (
Figure 28 ).
2. Move the wide-distribution impeller-gate lever
forward.
3. Attaching the cable to the ball stud at the gate
lever(
Figure 28 ).
Assembling the Impeller
1. Assemble impeller onto the impeller shaft and
secure the impeller with the drive pin.
2. Align the holes in the front cover with the clip
nuts in the chassis and secure the cover with
the 4 thumbscrews that you removed in step
3
of Removing the Impeller (page 26) .
28