Toro 31974, Operator'S Manual

Page: 15 / 28

Maintenance
Note:
Determine the left and right sides of the
machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 2 hours
• Tighten the castor wheel nuts.
After the first 10 hours
• Check the PTO driveshaft-to-gearbox fastener torque.
• Tighten the castor wheel nuts.
After the first 50 hours
• Change the gearbox lubricant.
Before each use or daily
• Lubricate the castor arm bushings.
• Clean the cutting unit.
Every 50 hours
• Lubricate the grease fittings. Lubricate the grease fittings immediately after every
washing.
• Check the gearbox lubricant.
• Tighten the castor wheel nuts.
• Check the blade drive belt adjustment.
• Clean under the cutting unit belt covers.
Every 100 hours
• Check the PTO driveshaft-to-gearbox fastener torque.
Every 400 hours
• Change the gearbox lubricant.
Daily Maintenance Checklist
Duplicate this page for routine use.
For the week of: Maintenance Check Item
Mon. Tues. Wed. Thurs. Fri. Sat. Sun.
Check the condition of the
blades
Lubricate all grease fittings 1
Touch-up damaged paint
1. Immediately after every washing, regardless of the interval listed.
Notation for Areas of Concern
Inspection performed by:
Item Date Information
CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition before you do any maintenance.
15