Toro 31698, Operator'S Manual, Page: 79 / 100

Installing the Batteries
1. Secure the batteries with the hold downs ( Figure
113 ).
2. Install the battery cables.
3. Position the battery cover in place and secure it
with the removed fasteners.
4. Install the rear shroud ( Figure 112 ).
5. Install the side shrouds ( Figure 111 ).
6. Raise the rear bumper into position and install
the flange screws. Tighten all the flange screws
securing the rear bumper to the frame (
Figure
110 ).
7. Turn the battery-disconnect switch to the O
N
position.
Drive System
Maintenance
Calibrating the Traction
Pedal
Service Interval: Every 1,000 hours—Calibrate the
traction pedal.
Contact your autorized Toro distributor or refer to the
Toro Service Manual for assistance.
Adjusting the
Traction-Pedal Angle
You can adjust the operating angle of the traction
pedal for your comfort.
1. Loosen the 2 nuts and bolts securing the left side
of the traction pedal to the bracket (
Figure 114 ).
g009745
Figure 114
1. Traction pedal 2. Mounting nuts and bolts
2. Pivot the pedal to the desired operating angle
and tighten the nuts (
Figure 114 ).
79