Toro 31698, Operator'S Manual, Page: 66 / 100

Front Cutting Unit
•
2 caster-fork-shaft bushings ( Figure 83 )
•
5 spindle-shaft bearings (located on the spindle
housing) as shown in
Figure 83
•
3 idler-arm-pivot bushings (located on the
idler-pivot shaft) as shown in
Figure 83
•
4 winglet-deck bushings (located on the
winglet-pivot pins) as shown in
Figure 83
g033268
Figure 83
Front Lift Assemblies
•
2 lift-arm bushings ( Figure 84 )
•
2 lift-arm-ball joints ( Figure 84 )
•
2 front deck lift-cylinder pivots ( Figure 84 )
g009247
Figure 84
Wing Cutting Units (Each Wing)
•
4 caster-fork-shaft bushing ( Figure 85 )
•
3 spindle-shaft bearings (located on the spindle
housing) as shown in
Figure 85
•
2 idler-arm-pivot bushings (located on the
idler-pivot shaft) as shown in
Figure 85
g009151
Figure 85
Wing Lift Assemblies (Per Wing)
•
3 main lift-arm bushings ( Figure 86 )
•
1 lift-cylinder bushing ( Figure 86 )
g009248
Figure 86
66