Toro 31698, Operator'S Manual, Page: 17 / 100

2. Remove the straps and braces securing the
wing decks for shipping.
2
Lowering the Front-Deck
Winglets
Parts needed for this procedure:
1 Right deck cover
1 Left deck cover
2 V-belt
Procedure
1. Remove the nuts securing the front and rear stop
bolts to the right winglet-deck mounts (
Figure 3 ).
g009013
Figure 3
1. Winglet 4. Eccentric
2. Hinge pin 5. Upper hole
3. Stop bolt 6. Deck mounts
2. While supporting the right winglet, remove the
front and rear stop bolts from the deck mounts
(
Figure 3 ).
Note:
Leave the eccentrics positioned between
the deck mounts.
3. Lower the winglet to the operating position.
4. Install the front and rear stop bolts through the
upper-mounting holes and eccentrics (
Figure 4 ).
Note:
Ensure that the stop bolt engages the tab
on the hinge pin.
g008868
Figure 4
1. Winglet 4. Eccentric
2. Hinge pin 5. Lower hole
3. Bolt
5. Install the nuts securing the stop bolts.
Note:
Do not tighten the nuts at this time.
6. Repeat this procedure on the left winglet.
7. Install the winglet belts as follows:
A. Start the belt around the winglet-spindle
pulley and the front-deck-spindle pulley
(
Figure 5 ).
g009155
Figure 5
1. Winglet-spindle pulley 3. Idler pulley
2. Front-deck-spindle pulley
17