•
Groundsmaster 4010 Machines: Use the
outside light-mount hole.
•
Groundsmaster 4110 Machines: Use the
inside light-mount hole.
g350532
Figure 12
Right headlight shown.
1.
Capscrew (headlight)
4.
Lock washer
2.
Outside light-mount hole
(Groundsmaster GM4010
machines)
5.
Locknut
3.
Inside light mount hole
(Groundsmaster GM4110
machines)
3.
Assemble the capscrew (12 mm) to the light
mount (
) with the locknut (12 mm) and
lock washer (12 mm).
4.
Tighten the locknut and capscrew.
5.
Repeat steps
through
for the headlight and
light mount for the other side of the machine.
Installing the Headlights
Machines with a Roll Bar
Important:
Ensure that you assemble the
headlight marked left at the left side of the
machine, and the headlight marked right at the
right side of the machine.
1.
Remove the cable tie securing the 6-socket
connector labeled H
EADLIGHT
LH and the
6-socket connector labeled H
EADLIGHT
RH of
the machine wire harness to the chassis of the
machine (
).
g350877
Figure 13
2.
Remove the cap from the 6-socket connector
labeled H
EADLIGHT
LH or the 6-socket connector
labeled H
EADLIGHT
RH of the machine wire
harness, and plug the connector into the
headlight (
8
Summary of Contents for 31693
Page 31: ...Notes ...
Page 32: ......
