Toro 31693, Installation Instructions Manual

Page: 19 / 32

g351027
Figure 39
1. 12-socket connector
(machine wire harness) 3. 12-pin connector (console
harness)
2. Cap
2. Plug the 12-pin connector of the console
harness into the 12-socket connector of the
machine wire harness (
Figure 39 ).
7
Installing the Fuses
Parts needed for this procedure:
1
Fuse (10 A)
1 Fuse (15 A)
Removing the Electrical Cover
Machines with a Roll Bar
At the floor along right side of the operator’s seat,
remove the 2 socket-head screws and 2 washers that
secure the controller cover to the electrical-component
mount, and remove the cover (
Figure 40 ).
g351012
g351093
Figure 40
1. Electrical cover 3. Washer
2. Socket-head screw 4. Clip nut
(electrical-component
mount)
Removing the Electrical Cover
Machines with a Cab
At the floor along right side of the operator’s seat,
remove the 2 socket-head screws that secure the
controller cover to the electrical-component mount,
and remove the cover (
Figure 41 ).
19